Home page Home page

Vpriv
velaglucerase alfa

Package leaflet: Information for the user


VPRIV 400 Units powder for solution for infusion

velaglucerase alfa


Read all of this leaflet carefully before you start using this medicine because it contains important information for you.



What VPRIV looks like and contents of the pack

20 ml glass vial containing a white to off-white powder for solution for infusion.


Packs of 1, 5 or 25 vials.

Not all pack sizes may be marketed.

Marketing Authorisation Holder and Manufacturer Marketing Authorisation Holder

Takeda Pharmaceuticals International AG Ireland Branch

Block 3 Miesian Plaza

50 – 58 Baggot Street Lower

Dublin 2 Ireland

Tel: + 800 66838470

E-mail: medinfoEMEA@takeda.com


Manufacturer

Takeda Pharmaceuticals International AG Ireland Branch

Block 3 Miesian Plaza

50 – 58 Baggot Street Lower

Dublin 2 Ireland


Shire Pharmaceuticals Ireland Limited Block 2 & 3 Miesian Plaza

50 – 58 Baggot Street Lower

Dublin 2 Ireland

This leaflet was last revised in .

. There are also links to other websites about rare diseases and treatments.


------------------------------------------------------------------------------------------------------------------------


The following information is intended for healthcare professionals only.


VPRIV is a powder for solution for infusion. It requires reconstitution and dilution and is intended for intravenous infusion only. VPRIV is for single–use only and is administered through a 0.2 or 0.22 µm filter. Discard any unused solution. VPRIV should not be infused with other medicines in the same infusion as the compatibility in solution with other medicines has not been evaluated. The total volume of infusion should be delivered over a period of 60 minutes.


Useaseptictechnique. Prepare VPRIV as follows:

  1. Determine the number of vials to be reconstituted based on the individual patient’s weight and

    the prescribed dose.

  2. Remove the required vials from the refrigerator. Reconstitute each vial using sterile water for injections:

    Vial size Water for injections 400 Units 4.3 ml


  3. Upon reconstitution, mix vials gently. Do not shake.

  4. Prior to dilution, visually inspect the solution in the vials; the solution should be clear to slightly opalescent and colourless; do not use if the solution is discoloured, or if foreign particulate matter is present.

  5. Withdraw the calculated volume of medicine from the appropriate number of vials. Some solution will remain in the vial:

    Vial size Extractable volume 400 Units 4.0 ml


  6. Dilute the total volume required in 100 ml of sodium chloride 9 mg/ml (0.9%) solution for infusion. Mix gently. Do not shake. Initiate the infusion within 24 hours from the time of reconstitution.


From a microbiological point of view, use the medicine immediately. If you do not immediately, in- use storage times and conditions prior to use are the responsibility of the user. Do not exceed 24 hours at 2 C to 8 C.


Do not dispose of the medicine via waste water or household waste. Dispose of any unused medicine or waste material in accordance with local requirements.


Keeping a record

In order to improve the traceability of biological medicine, record the name and batch number of the administered medicine clearly.