Home page Home page

Ixiaro
Japanese encephalitis vaccine (inactivated, adsorbed)

PACKAGE LEAFLET: INFORMATION FOR THE USER


IXIARO suspension for injection

Japanese encephalitis vaccine (inactivated, adsorbed)


Read all of this leaflet carefully before you or your child receive this vaccine because it contains important information for you.



  1. Contents of the pack and other information What IXIARO contains

1 dose (0.5 ml) of IXIARO contains:

Japanese encephalitis virus strain SA14-14-2 (inactivated)1,2 6 AU3 corresponding to a potency of ≤ 460 ng ED50


1 produced in Vero cells

2 adsorbed on aluminium hydroxide, hydrated (approximately 0.25 milligrams Al3+)

3 Antigen Units


Aluminium hydroxide is included in this vaccine as an adjuvant.


The other ingredients are: Sodium chloride, potassium dihydrogen phosphate, disodium hydrogen phosphate, water for injections


What IXIARO looks like and contents of the pack


IXIARO is a suspension for injection (0.5 ml in a glass syringe with or without a separate needle, pack size of 1).


IXIARO is a white and slightly milky sterile suspension, which becomes homogenous on shaking.


Marketing Authorisation Holder and Manufacturer


Marketing Authorisation Holder: Valneva Austria GmbH

Campus Vienna Biocenter 3

A-1030 Vienna Austria

Email: infoixiaro@valneva.com


Manufacturer:

image

Valneva Austria GmbH Campus Vienna Biocenter 3 A-1030 Vienna

Austria


For any information about this medicine, please contact the Marketing Authorization Holder by the following email-address:

infoixiaro@valneva.com


This leaflet was last revised in .

.

This leaflet is available in all EU/EEA languages on the European Medicines Agency website.

----------------------------------------------------------------------------------------------------------------------------

The following information is intended for healthcare professionals only:


The pre-filled syringe is for single use only and should not be used for more than one person. The pre-filled syringe is ready to use. If a needle is not provided, use a sterile needle.


Do not use if the blister foil is not intact or packaging is damaged.


Upon storage, a fine white deposit with a clear colourless supernatant can be observed.

Before administration, shake the syringe well to obtain a white, opaque, homogeneous suspension. Do not administer if particulate matter remains following shaking or if discoloration is observed or if the syringe appears to be physically damaged.


Any unused medicinal product or waste material should be disposed of in accordance with local requirements.


Information on the administration of a 0.5 ml dose of IXIARO for persons 3 years of age and above


For administration of the full 0.5 ml dose follow the steps below:


  1. Shake the syringe to obtain a homogeneous suspension.

  2. Remove the syringe tip cap by gently twisting it. Do not attempt to snap or pull the tip off as this may damage the syringe.

  3. Attach a needle to the pre-filled syringe.

Information on the preparation of a 0.25 ml dose of IXIARO for use in children below 3 years of age


For administration of a 0.25 ml dose in children aged 2 months to < 3 years, follow the steps below:


  1. Shake the syringe to obtain a homogeneous suspension.

  2. Remove the syringe tip cap by gently twisting it. Do not attempt to snap or pull the tip off as this may damage the syringe.

  3. Attach a needle to the pre-filled syringe.

  4. Hold the syringe in an upright position.

  5. Push the plunger stopper up to the edge of the red line on the syringe barrel, indicated by a red arrow (see Figure 1)*, to discard excess volume.

  6. Attach a new sterile needle prior to injection of the remaining volume.


*If you pushed the plunger stopper beyond the red line, a 0.25 ml dose is not guaranteed and a new syringe should be used.


Figure 1: Preparation for Administration of

0.25 ml Dose



image