Home page Home page

Vimizim
elosulfase alfa

Package leaflet: Information for the user


Vimizim 1 mg/ml concentrate for solution for infusion

elosulfase alfa


▼This medicine is subject to additional monitoring. This will allow quick identification of new safety information. You can help by reporting any side effects you may get. See the end of section 4 for how to report side effects.


Read all of this leaflet carefully before you start using this medicine because it contains important information for you.


What Vimizim looks like and contents of the pack

Vimizim is supplied as a concentrate for solution for infusion (sterile concentrate). The clear to slightly opalescent and colourless to pale yellow concentrate must be free of visible particles.


Pack sizes: 1 vial of 5 ml


Marketing Authorization Holder BioMarin International Limited Shanbally, Ringaskiddy

County Cork, P43 R298 Ireland


Manufacturer

BioMarin International Limited Shanbally, Ringaskiddy

County Cork Ireland


This leaflet was last revised in MM/YYYY


. There are also links to other websites about rare diseases and treatments.


<------------------------------------------------------------------------------------------------------------------------>

The following information is intended for medical or healthcare professionals only:


Vimizim should not be mixed with other medicinal products in the same infusion, except for those mentioned below.


Each vial of Vimizim is intended for single use only. Vimizim has to be diluted with sodium chloride 9 mg/ml (0.9 %) solution for infusion using aseptic technique. Diluted Vimizim solution is to be administered to patients using an infusion set. An infusion set equipped with an in-line 0.2 µm filter can be used.


Any unused product or waste material is to be disposed of in accordance with local requirements.


Preparation of the Vimizim infusion (Use aseptic technique)


  1. The number of vials to be diluted based on the individual patient's weight must be determined and removed from the refrigerator in advance in order to allow them to reach 23C – 27C. Do not heat or microwave vials. The recommended dose regimen is 2 mg/kg body weight administered once every week through a drip into a vein (by intravenous infusion). Each infusion will take approximately 4 hours.

    • Patient weight (kg) multiplied by 2 (mg/kg) = Patient dose (mg)

    • Patient dose (mg) divided by 1 (mg/ml concentrate of Vimizim) = Total number of ml of Vimizim

    • Total amount (ml) Vimizim divided by 5 ml per vial = Total number of vials


  2. The calculated total number of vials is rounded up to next whole vial.

  3. An infusion bag containing sodium chloride 9 mg/ml (0.9 %) solution for infusion is obtained suitable for intravenous administration. The total volume of the infusion is determined by the patient’s body weight.

    • Patients weighing less than 25 kg should receive a total volume of 100 ml.

      • Patients weighing 25 kg or more should receive a total volume of 250 ml.


  4. Before dilution, each vial is to be inspected for particulate matter and discolouration. The clear to slightly opalescent and colourless to pale yellow solution must be free of visible particles. Do not shake vials.


  5. A volume of the sodium chloride 9 mg/ml (0.9 %) solution for infusion is to be withdrawn and discarded from a 100 ml or 250 ml infusion bag equal to the total volume of Vimizim to be added.


  6. The calculated volume of Vimizim from the appropriate number of vials is slowly withdrawn using caution to avoid excessive agitation.


  7. The volume of Vimizim is to be slowly added to the sodium chloride 9 mg/ml (0.9 %) solution for infusion.


    When diluted with 100 ml sodium chloride 9 mg/ml (0.9 %) solution for infusion; the initial rate will be 3 ml/hr. The infusion rate will be increased every 15 minutes as follows: first increase the rate to 6 ml/hr, then increase the rate every 15 minutes by 6 ml/hr increments until a maximum rate of 36 ml/hr is reached.


    When diluted with 250 ml sodium chloride 9 mg/ml (0.9 %) solution for infusion; the initial rate will be 6 ml/hr. The infusion rate will be increased every 15 minutes as follows: first increase the rate to 12 ml/hr, then increase the rate every 15 minutes by 12 ml/hr increments until a maximum rate of 72 ml/hr is reached.


    Patient weight (kg)

    Total infusion volume (ml)

    Step 1 Initial infusion rate 0-15 minutes (ml/hr)

    Step 2

    15-30

    minutes (ml/hr)

    Step 3

    30-45

    minutes (ml/hr)

    Step 4

    45-60

    minutes (ml/hr)

    Step 5

    60-75

    minutes (ml/hr)

    Step 6

    75-90

    minutes (ml/hr)

    Step 7

    90+

    minutes (ml/hr)

    < 25

    100

    3

    6

    12

    18

    24

    30

    36

    ≥ 25

    250

    6

    12

    24

    36

    48

    60

    72

    Infusion rate may be increased as tolerated by patient.


  8. The diluted solution is to be mixed gently prior to infusion.


  9. The diluted solution is to be visually inspected for particulate matter prior to use. Do not use if the solution is discoloured or if there is particulate matter in the solution


  10. The diluted solution should be used immediately. If not used immediately, in-use storage times and conditions are the responsibility of the user and should normally not be longer than 24 hours

at 2C – 8C followed by up to 24 hours at 23C – 27C during administration.