Home page Home page

Cinryze
C1 inhibitor (human)

PACKAGE LEAFLET: INFORMATION FOR THE USER


Cinryze 500 IU powder and solvent for solution for injection

C1 inhibitor (human)


image

This medicine is subject to additional monitoring. This will allow quick identification of new safety information. You can help by reporting any side effects you may get. See the end of section 4 for how to report side effects.


Read all of this leaflet carefully before you start taking this medicine because it contains important information for you.



Use in children



Treatment of angioedema attacks

Pre-procedure prevention of angioedema attacks


Routine prevention of angioedema attacks


U2 to 11 years, >25 kg:

A dose of 1000 IU (two vials) of Cinryze should be injected at the first sign of a swelling attack.


A second injection of 1000 IU may be given if your symptoms do not improve after 60 minutes.


U2 to 11 years, 10-25 kg:

A dose of 500 IU (one vial) of Cinryze should be injected at the first sign of a

swelling attack.


A second injection of 500 IU may be given if your symptoms do not improve after 60 minutes.


U2 to 11 years, >25 kg: A dose of 1000 IU (two vials) of Cinryze should

be injected up to 24 hours before a medical, dental,

or surgical procedure.


U2 to 11 years, 10-25 kg:

A dose of 500 IU (one vial) of Cinryze should be

injected up to 24 hours

before a medical, dental, or surgical procedure.


U6 to 11 years:

A dose of 500 IU (one vial) of Cinryze should be

injected every 3 or 4 days for

routine prevention of swelling attacks.


The dosing interval may be adjusted by your doctor depending upon your response to Cinryze.

Reconstitution and method of administration


Cinryze is usually injected into a vein (intravenously) by your doctor or nurse. You or your carer might also administer Cinryze as an injection, but only after receiving adequate training. If you are injecting Cinryze yourself, always use it exactly as your doctor has instructed you. Check with your doctor if you are not sure. If your doctor decides that you may be suitable for such home-treatment, he/she will give you detailed instructions. You will be required to keep a diary in order to document each treatment received at home and to bring it to each of your visits to the doctor. Regular review of your/your carer’s injection technique will be performed to ensure continued appropriate handling.


If you have any further questions on the use of this medicine, ask your doctor or pharmacist.


  1. Possible side effects


    Like all medicines, this medicine can cause side effects, although not everybody gets them. This can include allergic-type reactions.

    Tell your doctor immediately if you experience any of the following symptoms after taking this medicine. Although they are rare, the symptoms can be severe.


    Sudden wheeziness, difficulty in breathing, swelling of eyelids, face or lips, rash or itching (especially affecting the whole body).


    UVerycommonsideeffects(Umay affect more than 1 in 10 people): headache, nausea.


    UCommonsideeffectsU (may affect up to 1 in 10 people): hypersensitivity, dizziness, vomiting, rash, itching or redness, injection site rash or pain, fever.


    UUncommonsideeffectsU (may affect up to 1 in 100 people): high blood sugar, blood clot, painful veins, hot flush, cough, stomach pain, diarrhoea, skin flaking, joint swelling and pain, muscle pain, and chest discomfort.


    Side effects in children and adolescents are expected to be similar to those in adults.


    Reporting of side effects


    If you get any side effects, talk to your doctor or nurse. This includes any possible side effects not listed in this leaflet. You can also report side effects directly via thenationalreportingsystemlistedin AppendixV. By reporting side effects you can help provide more information on the safety of this medicine.


  2. How to store Cinryze


    Keep this medicine out of the sight and reach of children.


    Do not use this medicine after the expiry date which is stated on the carton and vials after “EXP”. Store below 25C. Do not freeze. Store in the original package in order to protect from light.


    Once reconstituted, Cinryze solution should be used immediately.


    Do not throw away any medicines via wastewater or household waste. Ask your pharmacist how to throw away medicines you no longer use. These measures will help protect the environment.

  3. Contents of the pack and other information What Cinryze contains

The active substance is C1 inhibitor produced from the plasma of human donors. Each powder vial contains 500 IU of C1 inhibitor. After reconstitution, one vial contains 500 IU of C1 inhibitor (human)P Pper 5 ml, corresponding to a concentration of 100 IU/ml. Two vials of reconstituted Cinryze contain 1000 IU of C1 inhibitor (human)P Pper 10 ml, corresponding to a concentration of 100 IU/ml.


The total protein content of the reconstituted solution is 15 ± 5 mg/ml.


One International Unit (IU) is equivalent to the amount of C1 inhibitor present in 1 ml of normal human plasma.


UThe other ingredients are sodium chloride, sucrose, sodium citrate, L-valine, L-alanine and L- threonine. (See section 2).


Solvent: water for injections.


What Cinryze looks like and contents of the pack Powder and solvent for solution for injection. Cinryze is a white powder contained in a vial.

After it has been dissolved in the water for injections the solution is clear and colourless to slightly

blue.


Each pack contains:

2 vials of Cinryze 500 IU powder for solution for injection 2 vials of water for injections (5 ml each)

2 filter transfer devices

2 disposable 10 ml syringes

2 venipuncture sets

2 protective mats


Only use a silicone-free syringe (provided in the pack) for administration of the product.


Marketing Authorisation Holder and Manufacturer Marketing Authorisation Holder

Takeda Manufacturing Austria AG Industriestrasse 67

1221 Vienna Austria

E-mail: medinfoEMEA@takeda.com Tel: +800 66838470


Manufacturer


Takeda Manufacturing Austria AG Industriestrasse 67

image

1221 Vienna Austria


Shire International Licensing B.V. Mercuriusplein 11

2132 HA Hoofddorp The Netherlands

This leaflet was last revised in .

There are also links to other websites about rare diseases and treatments.

The following information is intended for healthcare professionals only: ReconstitutionandadministrationofCinryze

Reconstitution, product administration and handling of the administration set and needles must be done with caution.


Use either the filter transfer device provided with Cinryze or a commercially available double-ended needle.


Only use a silicone-free syringe (provided in the pack) for administration of the product. Preparationandhandling

Cinryze is intended for intravenous administration (into the vein) after reconstitution with water for injections.

Cinryze vial is for single use only.


Reconstitution


For a dose of 500 IU: One powder vial, 1 solvent vial, 1 filter transfer device, 1 disposable 10 ml syringe, 1 venipuncture set and 1 protective mat are needed. Store the remaining vial and administration equipments for the next dose.


For a dose of 1000 IU: Two powder vials, 2 solvent vials, 2 filter transfer devices, 1 disposable 10 ml syringe, 1 venipuncture set and 1 protective mat are needed.


Each product vial should be reconstituted with 5 ml water for injections.

One vial of reconstituted Cinryze corresponds to a dose of 500 IU. Therefore only reconstitute one vial of Cinryze for one dose of 500 IU.


Two vials of reconstituted Cinryze correspond to a dose of 1000 IU. Therefore two vials are combined for one dose of 1000 IU.


  1. Work on the mat provided and wash your hands before performing the following procedures.

  2. Aseptic technique should be used during the reconstitution procedure.

  3. Ensure the powder vial and the solvent vial are at room temperature (15ºC - 25ºC).

  4. Release the powder vial label by tearing down the perforated strip indicated by the inverted triangle.

  5. Remove plastic caps from the powder and solvent vials.

  6. Cleanse stoppers with a disinfection swab and allow them to dry prior to use.

  7. Remove protective covering from the top of the transfer device package. Do not remove the device from the package.

    image

  8. Note: the transfer device must be attached to the solvent vial before being attached to the powder vial, so that the vacuum in the powder vial is not lost. Place the solvent vial on a flat surface and insert the blue end of the transfer device into the solvent vial, pushing down until

    the spike penetrates through the centre of the solvent vial stopper and the device snaps in place. The transfer device must be vertical prior to penetrating the stopper closure.

    image

  9. Remove the plastic package from the transfer device and discard it. Take care not to touch the exposed end of the transfer device.

    image

  10. Place the powder vial on a flat surface. Invert the transfer device and the solvent vial containing water for injections and insert the clear end of the transfer device into the powder vial, pushing down until the spike penetrates the rubber stopper and the transfer device snaps into place.

    The transfer device must be vertical prior to penetrating the stopper closure of the powder vial. The vacuum in the powder vial will draw in the solvent. If there is no vacuum in the vial, do not

    use the product.

    image

    image


  11. Gently swirl the powder vial until all powder is dissolved. Do not shake the powder vial. Make sure all the powder is completely dissolved.

    image

  12. Disconnect the solvent vial by turning it anti-clockwise. Do not remove the clear end of the transfer device from the powder vial.

One vial of reconstituted Cinryze contains 500 IU of C1 inhibitor in 5 ml, resulting in a

concentration of 100 IU/ml. Proceed to administration process if patients receive a dose of 500 IU.

image

Two vials of Cinryze powder must be reconstituted to make one dose (1000 IU/10 ml). Therefore repeat instructions 1 to 12 above using an additional package containing a transfer device to reconstitute the second of two powder vials. Do not reuse the transfer device. Once the two vials are reconstituted proceed to administration process for a dose of 1000 IU.


Administration process for a dose of 500 IU


  1. Aseptic technique should be used during the administration procedure.

  2. After reconstitution, the Cinryze solutions are colourless to slightly blue and clear. Do not use the product if the solutions are turbid or discoloured.

  3. Using a sterile, disposable 10 ml syringe, draw back the plunger to allow approximately 5 ml of

    air into the syringe.

    image

  4. Attach the syringe onto the top of the clear end of the transfer device by turning it clockwise.

image


image

image

  1. Detach the syringe from the vial by turning it anti-clockwise and releasing it from the clear end of the transfer device.

    image

    image

  2. Inspect the reconstituted Cinryze solution for particulate matter prior to administration; do not use if particles are observed.

  3. Attach the venipuncture set to the syringe containing Cinryze solution and inject intravenously

(into the vein) into the patient. Administer 500 IU (reconstituted in 5 ml of water for injections) of Cinryze by intravenous injection at a rate of 1 ml per minute over 5 minutes.


Administration process for a dose of 1000 IU


  1. Aseptic technique should be used during the administration procedure.

  2. After reconstitution, the Cinryze solutions are colourless to slightly blue and clear. Do not use the product if the solutions are turbid or discoloured.

  3. Using a sterile, disposable 10 ml syringe, draw back the plunger to allow approximately 5 ml of air into the syringe.

    image

  4. Attach the syringe onto the top of the clear end of the transfer device by turning it clockwise.

    image


    image

    image

    1. Detach the syringe from the vial by turning it anti-clockwise and releasing it from the clear end of the transfer device.

      image

      image

    2. Using the same syringe, repeat steps 3 to 6 with a second vial of reconstituted Cinryze to make one complete 10 ml dose.

    3. Inspect the reconstituted Cinryze solution for particulate matter prior to administration; do not

      use if particles are observed.

    4. Attach the venipuncture set to the syringe containing Cinryze solution and inject intravenously (into the vein) into the patient. Administer 1000 IU (reconstituted in 10 ml of water for

injections) of Cinryze by intravenous injection (into the vein) at a rate of 1 ml per minute over

10 minutes.


Any unused medicinal product or waste material should be disposed of in accordance with local requirements.