Home page Home page

SonoVue
sulphur hexafluoride

Package leaflet: Information for the patient


SonoVue 8 microlitres/mL powder and solvent for dispersion for injection

image

sulphur hexafluoride


Read all of this leaflet carefully before you are given this medicine because it contains important information for you.

The glass syringe contains sodium chloride 9 mg/mL (0.9%) solution for injection.


What SonoVue looks like and contents of the pack


SonoVue is a kit which includes a glass vial containing white powder, a glass syringe containing the solvent and a transfer system.

Marketing Authorisation Holder and Manufacturer: Marketing authorisation holder

Bracco International B.V.

Strawinskylaan 3051

NL - 1077 ZX Amsterdam The Netherlands


Manufacturer:

Bracco Imaging S.p.A.

Via Ribes 5, Bioindustry Park Colleretto Giacosa - 10010 (TO)

Italy


This leaflet was last revised on

.


image


The following information is intended for healthcare professionals only:


If SonoVue is not used immediately after reconstitution the dispersion will be shaken again before being drawn up into a syringe.

The product is for a single examination only. Any unused liquid remaining at the end of an examination must be discarded.


Reconstitution instructions:


image

image

image

1 2 3

image

image

4 5


image

image

image

image

6 7 8


v1.0-08/2000 ©BRG 2000


  1. Connect the plunger rod by screwing it clockwise into the syringe.

  2. Open the MiniSpike transfer system blister and remove syringe tip cap.

  3. Open the transfer system cap and connect the syringe to the transfer system by screwing it in clockwise.

  4. Remove the protective disk from the vial. Slide the vial into the transparent sleeve of the transfer system and press firmly to lock the vial in place.

  5. Empty the contents of the syringe into the vial by pushing on the plunger rod.

  6. Shake vigorously for 20 seconds to mix all the contents in the vial to obtain a white milky homogeneous liquid.

  7. Invert the system and carefully withdraw SonoVue into the syringe.

  8. Unscrew the syringe from the system.


After reconstitution, SonoVue is a homogeneous white milky dispersion.

Do not use if the liquid obtained is clear and/or if solid parts of the lyophilisate are seen in the suspension.


SonoVue dispersion should be administered within six hours of its preparation.

Do not throw away any medicines via wastewater. Ask your pharmacist how to throw away medicines you no longer use. These measures will help protect the environment.


Annex IV


Scientific conclusions and grounds for the variation to the terms of the marketing authorisation(s)

Scientific conclusions


Taking into account the PRAC Assessment Report on the PSUR(s) for sulfur hexafluoride, the scientific conclusions of CHMP are as follows:


In view of available data on PEG allergy from the literature, spontaneous reports including in some cases a close temporal relationship and in view of a plausible mechanism of action, the PRAC considers that the warning section should be amended to highlight the role of PEG in the occurrence of rare but serious hypersensitivity reactions and to strengthen the existing wording about hypersensitivity reactions.


The PRAC concluded that the product information of products containing sulfur hexafluoride should be amended accordingly.


Grounds for the variation to the terms of the marketing authorisation(s)


On the basis of the scientific conclusions for sulfur hexafluoride the CHMP is of the opinion that the benefit-risk balance of the medicinal product(s) containing sulfur hexafluoride is unchanged subject to the proposed changes to the product information.


The CHMP recommends that the terms of the marketing authorisation(s) should be varied.