Home page Home page

Busulfan Fresenius Kabi
busulfan

Package leaflet: Information for the user


Busulfan Fresenius Kabi 6 mg/ml concentrate for solution for infusion

busulfan


Read all of this leaflet carefully before you start using this medicine because it contains important information for you.


Calculation of the quantity of Busulfan Fresenius Kabi to be diluted and of the diluent


Busulfan Fresenius Kabi must be diluted prior to use with either sodium chloride 9 mg/ml (0.9%) solution for injection or glucose solution for injection 5%.


The quantity of the diluent must be 10 times the volume of Busulfan Fresenius Kabi ensuring the final concentration of busulfan remains at approximately 0.5 mg/ml.


The amount of Busulfan Fresenius Kabi and diluent to be administered would be calculated as follows: for a patient with a Y kg body weight:

Diluted Busulfan Fresenius Kabi is a clear colourless solution


Instructions for use

Prior to and following each infusion, flush the indwelling catheter line with approximately 5 ml of sodium chloride 9 mg/ml (0.9%) solution for injection or glucose (5%) solution for injection.


The residual medicinal product must not be flushed in the administration tubing as rapid infusion of busulfan has not been tested and is not recommended.


The entire prescribed busulfan dose should be delivered over two or three hours depending on the conditioning regimen.


Small volumes may be administered over 2 hours using electric syringes. In that case infusion sets with minimal priming space should be used (i.e 0.3-0.6 ml), primed with medicinal product solution prior to beginning the actual busulfan infusion and then flushed with sodium chloride 9 mg/ml (0.9%) solution for injection or glucose (5%) solution for injection.


Busulfan must not be infused concomitantly with another intravenous solution.


Due to incompatibility, do not use infusion components containing polycarbonate with busulfan.


For single use only. Only a clear solution without particles should be used. Storage conditions

Unopened vials:

Store in a refrigerator (2°C – 8°C).


Diluted solution:

Chemical and physical in-use stability after dilution in glucose 5% or sodium chloride 9 mg/ml (0.9%) solution for injection has been demonstrated for 8 hours (including infusion time) after dilution when

stored at 25°C ± 2°C or 12 hours after dilution when stored at 2°C-8°C followed by 3 hours stored at

25°C ± 2°C (including infusion time).


From a microbiological point of view, the product should be used immediately after dilution.

If not used immediately, in-use storage times and conditions are the responsibility of the user and would normally not be longer than the above-mentioned conditions when dilution has taken place in controlled

and validated aseptic conditions.

Do not freeze the diluted solution.


  1. PROCEDURE FOR PROPER DISPOSAL


Any unused medicinal product or waste should be disposed of in accordance with local requirements for cytotoxic medicinal products.